Earthquake Energy Calculator: Compare Earthquake Energy
Energy released at a given magnitude
Try the calculator
Math runs in your browser. No sign-up.
Joules of radiated seismic energy.
A magnitude 7 releases about 476,879.14 tons of TNT equivalent.
Radiated energy follows log₁₀E = 1.5M + 4.8. A magnitude 7 releases about 2.0 × 10¹⁵ joules, roughly 477 kilotons of TNT — some 31,623 times the energy of a magnitude 4.
Earthquake magnitude is logarithmic, which makes the numbers deeply unintuitive. A one-point increase multiplies ground motion amplitude by ten but multiplies released energy by about 32, because energy scales as the three-halves power of magnitude. Two points therefore means roughly a thousand times the energy. This is why a magnitude 7 is not merely worse than a magnitude 5 but belongs to a different category of event entirely — about a thousandfold more energy, equivalent to roughly 477 kilotons of TNT against 0.48. The standard relationship, log₁₀E = 1.5M + 4.8, converts magnitude into joules of radiated seismic energy.
What is an earthquake energy?
Convert an earthquake magnitude into radiated seismic energy, TNT equivalent, and a direct comparison against any other magnitude. Magnitude scales are logarithmic in two distinct ways: ground motion rises tenfold per point while energy rises about 32-fold, and conflating the two is why the difference between a magnitude 5 and a magnitude 7 is so widely underestimated. Based on the Gutenberg–Richter relation log₁₀E = 1.5M + 4.8.
The formula
Source: Gutenberg–Richter energy relation, log10 E = 1.5M + 4.8.
Worked examples
1A major earthquake against a minor one
Magnitude 7 releases about 2.0 × 10¹⁵ joules, roughly 477 kilotons of TNT. Against a magnitude 4 that is 31,623 times the energy, though shaking amplitude is only 1,000 times greater. Magnitude 4 events happen somewhere daily and are rarely damaging; magnitude 7 events destroy cities.
2A single magnitude point
Magnitude 5 releases about 477 tons of TNT equivalent against magnitude 4's 15 tons — 31.6 times more from one point on the scale. This is the cleanest demonstration of the 10^1.5 relationship, and why seismologists report magnitudes to one decimal: a 5.3 and a 5.8 differ by nearly a factor of six in energy.
How to use this calculator
- Magnitude — Moment magnitude (Mw), the scale used for modern reporting.
- Compare against — A second magnitude for the energy-ratio comparison.
- Read the result. Use the worked examples below to sanity-check against a known scenario.
Common mistakes and edge cases
Confusing the amplitude ratio with the energy ratio
Ten times the shaking per point, but about 32 times the energy. Using the first where the second belongs understates the difference enormously.
Calling it the Richter scale
Modern reporting uses moment magnitude. The original local magnitude saturates above about 7, so it cannot distinguish the largest events from one another.
Equating magnitude with damage
Damage depends on depth, distance, local geology, building standards and duration. A shallow magnitude 6 beneath a city can be far deadlier than a deep magnitude 8 offshore.
Reading the TNT comparison too literally
The energy is comparable, but the release mechanism is not. A bomb releases energy at a point in microseconds; an earthquake releases it along hundreds of kilometres of fault over tens of seconds.
Frequently asked questions
how much more energy is a magnitude 7 than a 6
how do I convert magnitude to energy
is the Richter scale still used
why do similar magnitudes cause such different damage
is the TNT comparison meaningful
Earthquake Energy glossary
How we built this calculator
Methodology
Magnitude scales are logarithmic, and two different logarithmic relationships operate at once. Ground motion amplitude increases tenfold per magnitude point, which is what the original Richter scale measured from seismograph traces. Radiated energy, however, increases by 10^1.5 — about 31.6 — per point, because energy depends on both the amplitude and the duration of rupture.
Sources & references
Every numeric assumption traces to a primary source.
- U.S. Geological Survey — Earthquake Magnitude, Energy Release, and Shaking IntensityUSA
- Gutenberg B. & Richter C.F. (1956), Earthquake magnitude, intensity, energy and accelerationUSA
- Incorporated Research Institutions for Seismology — Magnitude ScalesUSA
- Numora Editorial Policy. numora.net/editorial-policy